There is a large gap between demand for energy and its generation. Organizations are actively looking for alternate ways to source energy due to the limited supply. However, there is an even better way to address the energy challenges: Use less energy! Is this really possible? Yes! And saving energy is the least expensive option. Alternate sources of energy production require heavy capital investment. The best way is to reduce consumption. The PowerSaver does exactly that!

Most high intensity discharge lamps require full mains only for initial ignition, which lasts only for a few minutes. Once the lights are ‘fully lit’, they do not require as much power to run. Graphay’s PowerSaver has a configurable start-up time for initial ignition, after which it reduces voltage. This reduces energy consumption while giving the same brightness. As much as 40% energy savings can be achieved using this methodology. The PowerSaver yields best results for fluorescent, high pressure sodium vapor, low pressure sodium vapor, mercury vapor and metal halide bulbs. You can use the it for  retail locations, offices, parking lots, campus and street lighting! Simply attach the right model to one or more circuits, or the main panel and start saving today!

1. Easy installation: simply attach to existing circuits in a couple of hours and start saving immediately
   

2. No replacement of bulbs necessary: avoid the cost of purchasing hundreds or even thousands of new bulbs, fixtures, and all the labor costs associated with it
   

3. Environmental friendly: no special handling or disposal required, since you use existing bulbs
   

4. Micro-Controller based digital controls for automatic savings
   

5. Integrates with existing systems: even if you have a mix of electronic ballast, magnetic ballast, switch start or inductive start
   

6. Works in hybrid environments: lights, ACs, fans, computers etc
   

7. Single and Three Phase models available
   

8. LCD panel displaying power consumption and power savings
   

9. Built-in fault protection: revert automatically to original mode in the event of a fault
   

1. Zero harmonics generation
   

2. Isolated RS485 half-duplex serial communication, industry standard MODBUS RTU protocol
   

3. Optional integrated server module for remote configuration and monitoring
   

4. Detailed logs of usage and savings
   

5. Increased lifespan of light bulbs (> 5000 hrs)
   

6. Conformance to Standards:
   

7. CE 89/336/EEC for Electromagnetic compatibility (Amended by 92/31/EEC & 93/68/EEC)
   

8. Standard EN 50081-1/1992, 50082-2/1998, EN 61000-3-2/2000 and EN 61000-3-3/1995
   

9. 73/23/EEC Low Equipment Directive (Amended by 93/68/EEC)
   

10. Immediate savings on Day One (ask about our profit-share model)